JMOON Conductive Gel M30U
JMOON Conductive Gel M30U
JMOON Conductive Gel is a lightweight microcurrent activator and conductive gel that provides up to 24 hours of hydration. Enriched with hyaluronic acid, it boosts microcurrent device performance while leaving skin refreshed, plump, and soft. Can be used daily with microcurrent tools or applied alone as a soothing hydrating gel.
960 in stock
Couldn't load pickup availability
Overview
Overview
• Boosts results with NouvelleSkin (enhances conductivity).
• 2.8 fl oz: Deeply hydrates for soft, smooth skin.
• Soothing & gentle—safe for most skin types (sensitive too).
• Fits JMOON NouvelleSkin microcurrent device.
• Easy to use: Lightweight, non-greasy, residue-free.
How to use
How to use
For a full-face session, use two quarter-sized amounts of gel (about 1.6mL in total). One tube can support approximately 50 sessions, which typically lasts around 2 months with regular use.
Share this product
How to Use
Step 1
Sensitivity Test
Step 2
Clean the Area
Step 3
Apply JMOON Gel
Step 4
Power on and Select a Mode/Level
Questions check here
How much gel do I need for each full-face session, and how long does one tube last?
How much gel do I need for each full-face session, and how long does one tube last?
For a full-face session, use two quarter-sized amounts of gel (about 1.6mL in total). One tube can support approximately 50 sessions, which typically lasts around 2 months with regular use.
Device Pre-use Guide: Cleansing & Skin Test
Device Pre-use Guide: Cleansing & Skin Test
Before using the device, cleanse your face thoroughly and avoid wearing makeup.
When using the JMOON NouvelleSkin facial toning device and its gel for the first time, a skin adaptation test is required. Follow these steps:
- Clean the Area: Wash the inside of your arm with soap or a facial cleanser, then dry it thoroughly with a towel.
- Apply the Gel: Dispense a small amount of the gel onto the inside of your arm.
- Use the Device: Set the device to LIFT mode at level 1 and gently glide it over the area for 3 minutes.
Monitor Reactions: If no skin issues (such as persistent redness, burning, or overheating) occur within 24 hours, you can use the product normally. However, if you notice rashes, redness, itching, or other unusual reactions before, during, or within 24 hours after the test, discontinue use immediately.
